[Pgpool-general] Authentication questions
Asaf
asaf at lingnu.com
Thu Oct 21 09:38:35 UTC 2010
On 10/20/2010 03:35 PM, Asaf wrote:
> I am using replication mode (3.0.1) and would like to use 'md5'
> authentication,
>
> if I configure only pg_hba.conf for 'md5', pgpool-II says:
>
> psql: ERROR: MD5 authentication is unsupported in replication,
> master-slave and parallel modes.
> HINT: check pg_hba.conf
>
> if I configure also pool_hba.conf usage, and put the same
> user/password into pool_password
> than it works.
>
> so it seems that the error message is incorrect, because MD5 is
> supported, but needs some
> additional configuration
>
> also, this forces me to duplicate the password
> (e.g: if I want to change password for a user, I need to do it in 2
> places)
>
>
> thanks
>
in addition, when configuring pg_hba to 'trust', and pool_hba to 'md5',
it does not prompt for password at all.
--
Asaf Ohaion
Lingnu Open Source Consulting Ltd.
http://www.lingnu.com
More information about the Pgpool-general
mailing list