[pgpool-general: 1111] Re: Configuring pgsql nodes

[Mino Haluz]

Thanks for info. I configured two nodes and pgpools and the first
pgpool boots up ok but second one cannot start because the first one
creates the virtual IP address already:

wd_init: delegate_IP already exists
2012-10-24 17:12:08 ERROR: pid 665: watchdog: wd_init failed
2012-10-24 17:12:08 ERROR: pid 665: wd_main error
2012-10-24 17:12:08 ERROR: pid 665: unlink(/tmp/.s.PGSQL.9898) failed:
No such file or directory
2012-10-24 17:12:08 DEBUG: pid 665: shmem_exit(1)

Am I missing something or I just did not understand it well ? :) Thanks.

On Wed, Oct 24, 2012 at 3:30 PM, Wolf Schwurack <wolf at uen.org> wrote:
> Take a look at this doc
>
> http://www.pgpool.net/pgpool-web/contrib_docs/watchdog_master_slave/en.html
>
> Wolf
>
>
> -----Original Message-----
> From: pgpool-general-bounces at pgpool.net [mailto:pgpool-general-bounces at pgpool.net] On Behalf Of Mino Haluz
> Sent: Wednesday, October 24, 2012 6:00 AM
> To: pgpool-general at pgpool.net
> Subject: [pgpool-general: 1106] Configuring pgsql nodes
>
> Hi,
>
> I want to test bit the replication mode of pgool-II, I configured the pgpool.conf but is there any manual how should I configure pgsql nodes so they could connect to the pgpool host ? Thank you,
>
> Mino Haluz
> _______________________________________________
> pgpool-general mailing list
> pgpool-general at pgpool.net
> http://www.pgpool.net/mailman/listinfo/pgpool-general